| Last Modified: 11-29-2007 | 1.6 J | |
| Service Category: Audio/Visual/Telematics | Section: Park Assist/Monitoring | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002BJ8005X |
| Title: PARK ASSIST / MONITORING: INTUITIVE PARKING ASSIST SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
Back Sonar Sensor RH Circuit |
DESCRIPTION
The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1. |
REPLACE BACK NO. 2 ULTRASONIC SENSOR RH |
(a) Replace the back No. 2 ultrasonic sensor with a normally functioning sensor
.
|
|
2. |
CHECK HARNESS AND CONNECTOR (BACK SENSOR RH - REAR CORNER SENSOR RH) |
|
(a) Disconnect the R3 back No. 2 ultrasonic sensor connector. |
(b) Disconnect the R2 rear corner No. 1 ultrasonic sensor connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Condition |
Condition |
Specified Condition |
|---|---|---|
|
R3-1 (BI) - R2-2 (BO) |
Always |
Below 1 Ω |
|
R3-3 (SI) - R2-4 (SO) |
||
|
R3-5 (EI) - R2-6 (EO) |
||
|
R3-1 (BI) - Body ground |
Always |
10 kΩ or higher |
|
R3-3 (SI) - Body ground |
||
|
R3-5 (EI) - Body ground |
(d) Reconnect the back No. 2 ultrasonic sensor connector.
(e) Reconnect the rear corner No. 1 ultrasonic sensor connector.
|
|
|